What aspects should we pay attention to when operating the sword-type packaging machine? And what are the maintenance methods?

What aspects should we pay attention to when operating the sword-style packaging machine? And what are the maintenance methods?

What aspects should we pay attention to when operating the sword-style packaging machine?

　　1. Adjusting the Belt Width and Joint Clearance: When the belt width is uneven or when switching to a belt of a different width, it’s essential to adjust the left and right belt insertion slots. If the slots are too narrow, the belt will be difficult to insert; if they’re too wide, the belt joint may overlap unevenly after being sealed by the packer. Typically, the slot width should be about 0.5 to 1 millimeter wider than the belt’s actual width.

　　2. The temperature setting of the flattening head on the strapping machine significantly affects the quality of belt splices. To ensure a strong bond in polypropylene strapping tape joints, the knob is typically adjusted to position 3–5. If the heating temperature is appropriate, check the adhesion on the surface of the heated area. If there are white marks on the heated surface, it means the temperature is too high; if the surface feels damp, it indicates the temperature is insufficient.

　　3. Adjust the binding tightness of the baling machine. Open the table surface, and manually loosen the Allen-head set screw at the top of the large ROM A—tighten it clockwise, or loosen it if necessary. Once the clamping force is just right, securely tighten the Allen-head set screw.

　　4. Adjusting the Belt Feed Length: The length of the belt feed is determined by the belt feed length regulator located on the front panel. If the belt is too short, it can easily get caught in your hand. In this case, you can manually grip the guide wire and pull the belt out along its feeding direction. However, be sure to readjust the belt feed length afterward to ensure smooth operation for the next baling cycle. On the other hand, if the sealer’s strap is too long, it becomes difficult to align properly, increasing the risk of the sealer strap tangling with the Panasonic strap—potentially leading to misalignment or even breakage of the strap.

Maintenance for the sword-style packer: 1. Always keep the machine’s interior clean and dry. 2. Be careful not to place wet or dirty objects on the machine’s baseplate. 3. Avoid coiling the power cord—when not in use, please wind it neatly. 4. Ensure the machine operates smoothly and always use the correct polarity cable.

Additionally, the daily maintenance of the sword-type packer should follow these six key steps:

　　(1) Once a week, remove debris or dirt from the machine.

　　(2) As mentioned in the previous section, the upper slide, middle cutter, and front top cutter should be cleaned, maintained, and lubricated once a month.

　　(3) Once every three months, in addition to completing the two maintenance tasks mentioned above, apply some lubricant to all (shafts, cores) and bearings.

　　(4) Top up the transmission oil every two years.

　　(5) It's important to note that several parts should not be lubricated: the return belt roller, all belts, and the slip mechanism along with its surroundings.

(6) Don't add too much oil each time, as this could cause the microswitch to fail due to oil immersion.

So, if you want your sword-style packer to perform better, make sure to pay attention to maintenance. If you’d like to learn more about operating the sword-style packer, feel free to reach out to the manufacturer—we’re here to answer all your questions!